Where has compaction been carried out already? How high is the degree of compaction? These typical project manager questions can be answered quickly and easily using Compamatic.
Compamatic is a combination of the time-tested and proven Compatec compaction control by Wacker Neuson and a Telematics module. Wacker Neuson now also introduces the system for the reversible vibratory plates DPU80, DPU90, DPU110 and the remote-controlled versions DPU80r and DPU110r in the range from 80 to 110 Kilonewtons. Compamatic is likewise available for the coupling set of the DPU110 model. On the one hand, Compamatic results in enormous time savings on complex large construction sites, as quality assurance is enabled via the EquipCare Manager, therefore making fewer on-site inspections necessary. Even for small businesses, easier quality control results in time and cost savings. A vibratory plate equipped with Compamatic sends data for quality control to the Wacker Neuson EquipCare Telematics solution. The exact machine location is recorded via GPS. At the same time, the Compatec compaction control reads out the compaction data at the relevant point in time. In the EquipCare Manager, a satellite image with a "heat map" uses different colors to show where compaction has taken place and how much.
As Compamatic is integrated into Wacker Neuson's existing EquipCare Telematics solution, customers can easily access machine data and check compaction progress via EquipCare Manager on a PC.
More information can be found at: www.youtube.com/watch